Jersey Lettering Font Size
About Dallas Cowboys Font. Along with the star logo is the script logotype and the lettering is very similar to a font called Cowboys by Sharkshock. The font is available in capital letters, numbers and limited punctuations marks. ENTER FONT SIZE: SELECT AN EFFECT.
You can use a ruler to measure and spend the extra time for each shirt if it suits you. General rule of thumb for a full front print is 3 fingers down from the bottom of the collar. Your best bet is find what is right for you and your shop and you must have your screen room on the ball. All artwork should be burned in the same spot every time ie. Top of image is 6' down from the bottom of the screen frame. This way when you load your shirts in the same spot all the time then its always right on.
Jersey Lettering Font Size Free
Speed is the key and pre press is always where the most time can be saved. I use my handy dandy left hand measuring tool. Its always attached to the end of my left arm so it never gets lost I go 4 fingers down from the collar on the front, and just under the front collar impression on the backside of the shirt. Everyones fingers are different so I measured mine and the 4 fingers measure 3.5' I also use my left hand to guage where to put left chest logos. I put the middle knuckle on my pinky finger at the middle of the bottom edge of the collar, then place the graphic 4 fingers down, at the tip of my middle finger across (imaginary line) that measures 4' over from center line hope that helps, you can tape up on a shirt where the graphic should go then put your hand on the edge of the collar to figure out your own handy dandy left hand tool too. Depending on your hand size placement is different!